Custom sizes are available if required.
Widths available: Any width between 12 mm to 950mm
Thickness available : 3mm, 5mm, 10mm, 12mm
PE "Noise stop" foam tape for Lapseal
The PE foam tape used as a “weather strip” on top of one polycarbonate roof sheet when another is laid over it. They are typically fitted across the full width of the sheet, often with 2 strips – one approximately 50mm below the top of the bottom sheet, and the other approximately 25mm above the bottom of the overlapping sheet.
PE "Noise stop" foam tape for Purlin
PE "Noise stop" foam tape, with self-adhesive backing, is fitted to wooden or steel purlins to prevent noise (squeaking) caused by expansion and contraction of polycarbonate sheets during temperature variations. These tapes are used either when polycarbonate sheeting is installed between metal sheets (to allow light to penetrate to the space below), or when the entire roof uses polycarbonate roofing. Purlin tapes are normally installed along the full width of the purlin prior to placing the polycarbonate on the roof structure.
Noise stop foam for Back channel tapes
The foam tape is fitted into a “C-section” channel mounted on a wall, into which sheets of roofing are pushed in at a slight angle. This is typically used when they are fitted under a gutter in awnings and patios. The foam does not hold water, and will compress when the sheets are pushed into it, to create a watertight seal, preventing rain from blowing up the sheets and running down the wall.
Contact us